Pool Pump Repair in Toronto & GTA
Repair for single-speed, two-speed and variable-speed pool pumps and their motors, from pumps that will not prime to leaks and electrical faults.
Pool Pump Repair: what we fix
The problems we are called for most often. Not on the list? Describe it in your request.
Will not prime
Air leaks at the lid, unions and suction lines, and low water.
Hums but will not start
Failed capacitors, seized motors and impellers jammed with debris.
Leaking at the pump
Worn shaft seals, cracked housings and leaking unions.
Loud or screeching
Worn motor bearings and cavitation from restricted suction.
Trips the breaker
Motor windings, wiring and bonding faults.
Variable-speed drive errors
Drive faults, communication errors and settings.
Brands we service
Hayward
Pentair
JandyZodiac
Brand names and logos are trademarks of their respective owners. CAP Service Pro is an independent service company and is not affiliated with these manufacturers.
Pool Pump Repair in the GTA
The filter, the heater and the chlorinator all depend on the pump moving enough water. The most common pump problem is air on the suction side. A loose lid, a dry lid O-ring, a cracked union or a low water level lets air in, and the pump loses prime, runs loud and moves little water. A pump that hums but will not start usually has a failed capacitor or a seized motor or impeller, often after sitting over the winter. Water dripping under the motor means the shaft seal is worn, and screeching points to failing motor bearings. Variable-speed pumps add drive and communication faults.
Before you call
- Check the water level and clean the pump and skimmer baskets.
- Inspect the lid O-ring: a light coat of pool lubricant often stops air leaks.
- Note whether the pump hums, runs without moving water, trips the breaker or shows a drive error.
Repair or replace?
Capacitors, seals, bearings and impellers are inexpensive repairs, and replacing only the motor is often better value than replacing the whole pump. If an older single-speed pump needs a new motor, we can compare that with a variable-speed pump, which uses much less electricity over a season.
The diagnostic visit is a flat $99, and you get the repair price before any work begins. Completed repairs are covered by our warranty. We repair pool pumps at homes and commercial facilities across Toronto and the GTA.
How a service call works
Step 1: Request
Book a time online, or call, email or send the form and we set a time with you.
Online, phone or emailStep 2: Diagnose
A technician inspects the equipment and finds the actual cause.
Flat $99 diagnosticStep 3: Quote
You approve the price before any repair work begins.
Price before any workStep 4: Repair
The repair is completed and tested before we leave.
Covered by warranty
Common questions
Anything else? Call us and ask.
My pump runs but there is no water flow. What should I check?
Make sure the water level is above the skimmer opening and the pump basket and skimmer baskets are clean. If it still will not prime, send us a request.
Is it worth replacing the motor instead of the whole pump?
Often it is. After the diagnostic we tell you which option makes sense for your pump.
Across the Greater Toronto Area
Toronto and communities within about 50 km of downtown. Pick a place on the map to check it.Not sure if we cover your address? Send your postal code with the request.
- Toronto
- North York
- Scarborough
- Etobicoke
- Mississauga
- Brampton
- Vaughan
- Markham
- Richmond Hill
- Oakville
- Pickering
- Ajax
- Whitby
- Oshawa
- Milton
- Burlington
- Aurora
- Newmarket

Service available
Toronto
The centre of our service area: everything within 50 km of downtown.
Brands we service
All major residential and light-commercial manufacturers. Brand names are trademarks of their respective owners; CAP Service Pro is an independent service company. Map data © OpenStreetMap contributors.
