Furnace Repair in Toronto & GTA
Repair for gas and electric forced-air furnaces, from no heat and short cycling to ignition faults, noisy blowers and error codes.
Furnace Repair: what we fix
The problems we are called for most often. Not on the list? Describe it in your request.
No heat
Igniters, flame sensors, gas valves and control boards that stop the furnace from lighting.
Runs a few minutes and stops
Short cycling from dirty flame sensors, overheating or pressure switch faults.
Blower will not stop or start
Blower motors, capacitors, relays and control boards.
Loud banging or squealing
Delayed ignition, worn blower bearings and loose parts.
Flashing error light
Diagnostic codes on the control board traced to the failed part.
Some rooms stay cold
Airflow problems, dirty filters, dampers and blower speed settings.
Brands we service
Carrier
Lennox
Goodman
Rheem
Trane
YorkBryant
Amana
American Standard
Napoleon
KeepRite
Brand names and logos are trademarks of their respective owners. CAP Service Pro is an independent service company and is not affiliated with these manufacturers.
Furnace Repair in the GTA
A modern gas furnace lights in a strict order: the inducer fan starts, a pressure switch confirms the venting, the igniter heats, the gas valve opens and the flame sensor proves the flame. If any step fails, the control board stops and usually flashes a code. That is why most no-heat calls come down to a few parts: a cracked hot surface igniter, a dirty flame sensor that shuts the burners off after a few seconds, a pressure switch tripped by a blocked vent or condensate drain, or a failed inducer motor. Short cycling, a furnace that runs a few minutes and stops, is very often the flame sensor or an overheating problem from a dirty filter.
Before you call
- If your carbon monoxide alarm sounds, leave the home and call 911 from outside.
- Check the filter, the thermostat batteries and the furnace switch, which often looks like a light switch near the unit.
- Look through the small window on the furnace door and note the pattern of the flashing light.
Repair or replace?
Igniters, flame sensors, pressure switches, inducer and blower motors and control boards are standard repairs on every brand. A cracked heat exchanger is a safety issue, and on an older furnace it is usually the point where replacement is the better choice. We check the safety controls before the furnace goes back into service.
The diagnostic visit is a flat $99, and you get the repair price before any work begins. Completed repairs are covered by our warranty. We repair gas and electric furnaces across Toronto and the GTA, and a fall tune-up before the cold arrives catches most of these parts early.
How a service call works
Step 1: Request
Book a time online, or call, email or send the form and we set a time with you.
Online, phone or emailStep 2: Diagnose
A technician inspects the equipment and finds the actual cause.
Flat $99 diagnosticStep 3: Quote
You approve the price before any repair work begins.
Price before any workStep 4: Repair
The repair is completed and tested before we leave.
Covered by warranty
Common questions
Anything else? Call us and ask.
My carbon monoxide alarm is going off. What should I do?
Leave the home right away and call 911 from outside. Do not go back in until the fire department says it is safe. We can inspect the furnace after that.
My furnace runs for a while and then shuts off. Why?
Often a dirty flame sensor, a blocked filter or vent, or a pressure switch fault. The flashing light on the control board usually points to the cause.
Do you do furnace tune-ups before winter?
Yes. A fall tune-up checks ignition, the burners, the blower and the safety controls before the cold arrives.
Across the Greater Toronto Area
Toronto and communities within about 50 km of downtown. Pick a place on the map to check it.Not sure if we cover your address? Send your postal code with the request.
- Toronto
- North York
- Scarborough
- Etobicoke
- Mississauga
- Brampton
- Vaughan
- Markham
- Richmond Hill
- Oakville
- Pickering
- Ajax
- Whitby
- Oshawa
- Milton
- Burlington
- Aurora
- Newmarket

Service available
Toronto
The centre of our service area: everything within 50 km of downtown.
Brands we service
All major residential and light-commercial manufacturers. Brand names are trademarks of their respective owners; CAP Service Pro is an independent service company. Map data © OpenStreetMap contributors.

