Pool Heater Repair in Toronto & GTA
Repair for natural gas and propane pool and spa heaters, from units that click without lighting to error codes, sooting and slow heating.
Pool Heater Repair: what we fix
The problems we are called for most often. Not on the list? Describe it in your request.
Will not fire
Igniters, gas valves, flame sensors and control boards.
Shuts off after starting
Pressure switches, high-limit switches and flow problems.
Error code on the panel
Fault codes traced to the switch or sensor that sets them.
Heats slowly
Scale in the heat exchanger, low gas pressure and bypass settings.
Soot or rust
Burner and venting problems that need attention before the next season.
Leaking water
Heat exchanger, header and fitting leaks.
Brands we service
Hayward
Pentair
Raypak
JandyZodiac
Brand names and logos are trademarks of their respective owners. CAP Service Pro is an independent service company and is not affiliated with these manufacturers.
Pool Heater Repair in the GTA
A gas pool heater has several safety switches in series, and it will not fire unless every one of them agrees: water pressure, high-limit temperature, flue and gas pressure. That is why a heater that clicks and stops, or starts and shuts off after a minute, is usually reporting a condition somewhere else in the system. Low water flow from a dirty filter or a bypass valve set wrong is a common cause. Igniters and flame sensors wear out, gas valves fail, and on heaters that sat through a wet winter, rust, nests and debris in the burner tray and venting cause sooting and poor flames. Scale in the heat exchanger on hard-water pools makes the heater slow.
Before you call
- Clean the filter and check that the pump runs at a speed the heater needs.
- Make sure the gas supply valve to the heater is open.
- Write down the code on the heater display and whether it clicks, lights briefly or does nothing.
Repair or replace?
Igniters, sensors, switches, gas valves and control boards are standard repairs on Hayward, Pentair, Raypak, Jandy and Zodiac heaters. In Ontario the heater must be drained and protected before winter to avoid freeze damage, and we do that as part of pool closing.
The diagnostic visit is a flat $99, and you get the repair price before any work begins. Completed repairs are covered by our warranty. We repair natural gas and propane pool and spa heaters across Toronto and the GTA.
How a service call works
Step 1: Request
Book a time online, or call, email or send the form and we set a time with you.
Online, phone or emailStep 2: Diagnose
A technician inspects the equipment and finds the actual cause.
Flat $99 diagnosticStep 3: Quote
You approve the price before any repair work begins.
Price before any workStep 4: Repair
The repair is completed and tested before we leave.
Covered by warranty
Common questions
Anything else? Call us and ask.
My heater clicks but will not light. What could it be?
Common causes are the igniter, the gas supply, the pressure switch or low water flow. Send us the model and any code on the display.
There is soot or rust on my heater. Is it safe to use?
Turn it off until it is checked. Soot means the burners are not burning cleanly, usually from blocked burners, poor venting or low gas pressure, and rust often points to a leak or condensation inside the cabinet.
Across the Greater Toronto Area
Toronto and communities within about 50 km of downtown. Pick a place on the map to check it.Not sure if we cover your address? Send your postal code with the request.
- Toronto
- North York
- Scarborough
- Etobicoke
- Mississauga
- Brampton
- Vaughan
- Markham
- Richmond Hill
- Oakville
- Pickering
- Ajax
- Whitby
- Oshawa
- Milton
- Burlington
- Aurora
- Newmarket

Service available
Toronto
The centre of our service area: everything within 50 km of downtown.
Brands we service
All major residential and light-commercial manufacturers. Brand names are trademarks of their respective owners; CAP Service Pro is an independent service company. Map data © OpenStreetMap contributors.
