Ductless Mini-Split Repair in Toronto & GTA
Repair for ductless mini-split and multi-zone systems, from indoor units that blow warm or cold air to leaks, error codes and noisy fans.
Ductless Mini-Split Repair: what we fix
The problems we are called for most often. Not on the list? Describe it in your request.
Not heating or cooling
Sensors, boards, refrigerant problems and outdoor unit faults.
Water dripping from the indoor unit
Blocked condensate drains and dirty coils.
Blinking lights or error code
Fault codes traced to the sensor or board that sets them.
Indoor unit will not turn on
Remote, power, communication and board problems.
Bad smell from the unit
Mould and dirt in the coil and blower wheel that need a deep clean.
Loud fan or rattling
Dirty blower wheels, loose louvres and worn fan motors.
Brands we service
Mitsubishi Electric
Daikin
Fujitsu
LG
Samsung
Gree
Midea
Panasonic
Carrier
Brand names and logos are trademarks of their respective owners. CAP Service Pro is an independent service company and is not affiliated with these manufacturers.
Ductless Mini-Split Repair in the GTA
Ductless mini-splits pack a compressor, a fan coil and a lot of electronics into small units, and they talk to each other through a communication wire. That design makes them efficient, and it also means a single fault is reported as a blinking code rather than an obvious symptom. The most common calls are indoor units that drip water because the condensate drain or pan is blocked, units that blow air but do not heat or cool because of a sensor, board or refrigerant problem, and communication errors between the indoor and outdoor units. Dirty coils and blower wheels cause musty smells, weak airflow and noise.
Before you call
- Clean the washable filters behind the front panel of each indoor unit.
- Replace the remote batteries and check that the mode and set temperature are what you expect.
- Write down the blinking pattern or code and the model numbers of both indoor and outdoor units.
Repair or replace?
Drains, sensors, boards, fan motors and refrigerant leaks are repairable on Mitsubishi Electric, Daikin, Fujitsu, LG, Samsung and other major brands. A deep clean of the indoor coil and blower wheel fixes many smell, airflow and dripping problems on its own.
The diagnostic visit is a flat $99, and you get the repair price before any work begins. Completed repairs are covered by our warranty. We service single-zone and multi-zone ductless systems across Toronto and the GTA.
How a service call works
Step 1: Request
Book a time online, or call, email or send the form and we set a time with you.
Online, phone or emailStep 2: Diagnose
A technician inspects the equipment and finds the actual cause.
Flat $99 diagnosticStep 3: Quote
You approve the price before any repair work begins.
Price before any workStep 4: Repair
The repair is completed and tested before we leave.
Covered by warranty
Common questions
Anything else? Call us and ask.
My mini-split is blinking. What should I send?
The brand, the model number of the indoor and outdoor units and the blinking pattern or code.
Do you clean mini-split indoor units?
Yes. A deep clean of the coil and blower wheel fixes many smell, airflow and dripping problems.
Across the Greater Toronto Area
Toronto and communities within about 50 km of downtown. Pick a place on the map to check it.Not sure if we cover your address? Send your postal code with the request.
- Toronto
- North York
- Scarborough
- Etobicoke
- Mississauga
- Brampton
- Vaughan
- Markham
- Richmond Hill
- Oakville
- Pickering
- Ajax
- Whitby
- Oshawa
- Milton
- Burlington
- Aurora
- Newmarket

Service available
Toronto
The centre of our service area: everything within 50 km of downtown.
Brands we service
All major residential and light-commercial manufacturers. Brand names are trademarks of their respective owners; CAP Service Pro is an independent service company. Map data © OpenStreetMap contributors.

