Boiler Repair in Toronto & GTA
Repair for gas hydronic and combi boilers, from no heat and low pressure to leaks, kettling noises, circulator pumps and error codes.
Boiler Repair: what we fix
The problems we are called for most often. Not on the list? Describe it in your request.
No heat or no hot water
Ignition, gas valve, circulator pump and control faults.
Low or high pressure
Leaks, failed expansion tanks, fill valves and relief valves.
Radiators not warming
Air in the system, failed zone valves and circulator pumps.
Kettling or banging noise
Scale in the heat exchanger and flow problems.
Water leaking
Leaking valves, fittings, pumps and relief valves.
Error code on the display
Fault codes traced to the sensor or part that sets them.
Brands we service
Viessmann
NavienWeil-McLain
Buderus
LochinvarNTI
IBCCarrier
Brand names and logos are trademarks of their respective owners. CAP Service Pro is an independent service company and is not affiliated with these manufacturers.
Boiler Repair in the GTA
A hydronic boiler heats water and circulates it through radiators, baseboards or in-floor loops, so a problem can sit in the boiler itself or anywhere in the loop. No heat at all usually means an ignition, gas valve or control fault. Heat in some rooms but not others points to air in the system, a failed zone valve or a circulator pump that has stopped. Pressure that keeps dropping means water is leaving the system through a leak, a relief valve or a failed expansion tank, while kettling and banging usually come from scale inside the heat exchanger on hard-water systems.
Before you call
- Check the pressure gauge: most residential systems run around 12 to 15 psi when cold.
- Bleed air from the radiators at the top of the house if they are cold at the top and warm at the bottom.
- On combi boilers, note whether you lost heating, hot water or both, and write down any error code.
Repair or replace?
Pumps, zone valves, expansion tanks, relief valves, igniters and sensors are routine repairs on boilers from Viessmann, Navien, Weil-McLain, Buderus, Lochinvar and other major brands. A cracked heat exchanger on an older cast-iron boiler is the point where replacement usually makes more sense.
The diagnostic visit is a flat $99, and you get the repair price before any work begins. Completed repairs are covered by our warranty. We service boilers in homes, multi-unit buildings and commercial spaces across Toronto and the GTA.
How a service call works
Step 1: Request
Book a time online, or call, email or send the form and we set a time with you.
Online, phone or emailStep 2: Diagnose
A technician inspects the equipment and finds the actual cause.
Flat $99 diagnosticStep 3: Quote
You approve the price before any repair work begins.
Price before any workStep 4: Repair
The repair is completed and tested before we leave.
Covered by warranty
Common questions
Anything else? Call us and ask.
My boiler pressure keeps dropping. Is that a problem?
Usually it points to a leak, a failed expansion tank or a relief valve. Repeated refilling hides the cause, so it is worth a diagnostic visit.
Do you service combi boilers?
Yes. We service combi boilers that supply both heating and domestic hot water.
Across the Greater Toronto Area
Toronto and communities within about 50 km of downtown. Pick a place on the map to check it.Not sure if we cover your address? Send your postal code with the request.
- Toronto
- North York
- Scarborough
- Etobicoke
- Mississauga
- Brampton
- Vaughan
- Markham
- Richmond Hill
- Oakville
- Pickering
- Ajax
- Whitby
- Oshawa
- Milton
- Burlington
- Aurora
- Newmarket

Service available
Toronto
The centre of our service area: everything within 50 km of downtown.
Brands we service
All major residential and light-commercial manufacturers. Brand names are trademarks of their respective owners; CAP Service Pro is an independent service company. Map data © OpenStreetMap contributors.

