Dishwasher Repair in Toronto & GTA
Repair for built-in and panel-ready dishwashers of all major brands, from drain and fill problems to leaks, error codes and dead controls.
Dishwasher Repair: what we fix
The problems we are called for most often. Not on the list? Describe it in your request.
Will not drain
Standing water from a blocked filter, a failed drain pump or a kinked hose.
Dishes not clean
Weak spray from clogged arms, a failing wash pump or low water.
Leaking water
Worn door gaskets, loose hoses, a cracked sump or a failed water valve.
Will not start or fill
Door latches, water inlet valves, float switches and controls.
Error code or blinking lights
Fault codes traced to the sensor or part that sets them.
Not drying
Failed heating elements, rinse aid and fan problems.
Brands we service
Bosch
Miele
KitchenAid
Whirlpool
Samsung
LG
GE
Frigidaire
Maytag
ThermadorFisher & Paykel
Brand names and logos are trademarks of their respective owners. CAP Service Pro is an independent service company and is not affiliated with these manufacturers.
Dishwasher Repair in the GTA
A dishwasher repeats the same short sequence every cycle: fill, heat, wash, drain and dry. When it fails, the step where it stops tells us most of the story. Water left in the tub points to the drain side, usually a clogged filter, a blocked drain hose or air gap, or a failed drain pump. A dishwasher that hums but never fills usually has a failed water inlet valve or a float switch stuck up. Dishes that come out dirty point to the wash pump, clogged spray arms or water that never gets hot enough, and a dishwasher that does nothing at all is often a door latch or control fault.
Before you call
- Remove and rinse the filter at the bottom of the tub; on many newer models it is the cause of poor draining and cleaning.
- Check that the drain hose under the sink is not kinked and the garbage disposal knockout plug was removed.
- Write down any error code or the pattern of blinking lights.
Repair or replace?
Pumps, valves, latches and sensors are standard repairs, and on built-in and panel-ready models from Bosch, Miele, Thermador and similar brands they are almost always worth doing. A leaking tub or a rusted frame on an older budget model is usually the point where replacement makes more sense.
The diagnostic visit is a flat $99, and you get the repair price before any work begins. Completed repairs are covered by our warranty. We repair dishwashers in homes, rental units and commercial kitchens across Toronto and the GTA.
How a service call works
Step 1: Request
Book a time online, or call, email or send the form and we set a time with you.
Online, phone or emailStep 2: Diagnose
A technician inspects the equipment and finds the actual cause.
Flat $99 diagnosticStep 3: Quote
You approve the price before any repair work begins.
Price before any workStep 4: Repair
The repair is completed and tested before we leave.
Covered by warranty
Common questions
Anything else? Call us and ask.
My dishwasher shows an error code. What should I send?
The brand, the model number and the code itself. A photo of the display or the blinking lights helps.
Where is the model number on a dishwasher?
Usually on a label on the edge of the door or the side of the tub, visible with the door open.
Across the Greater Toronto Area
Toronto and communities within about 50 km of downtown. Pick a place on the map to check it.Not sure if we cover your address? Send your postal code with the request.
- Toronto
- North York
- Scarborough
- Etobicoke
- Mississauga
- Brampton
- Vaughan
- Markham
- Richmond Hill
- Oakville
- Pickering
- Ajax
- Whitby
- Oshawa
- Milton
- Burlington
- Aurora
- Newmarket

Service available
Toronto
The centre of our service area: everything within 50 km of downtown.
Brands we service
All major residential and light-commercial manufacturers. Brand names are trademarks of their respective owners; CAP Service Pro is an independent service company. Map data © OpenStreetMap contributors.

